Binding Cables; Attaching The Carrying Handles - Sharp PN-455RU Operation Manual

Binding Cables

The power cord can be fastened using the supplied power cord clamp. This will prevent the power cord
from being disconnected accidentally.
Also, the cables connected to the terminals on the back of the monitor can be neatly bundled using the
supplied cable clamps as shown in the illustration below.
1
Band
Power card
Fastened
clamp
part
Fastening the power cord
1. Attach the supplied power cord clamp to the power cord, making sure the power cord clamp is
circular hole-sidedown.
2. Insert the tip of the band into the hole for the power cord clamp.
3. While holding the tail of the band, slide the fastened part toward the AC input terminal.

Attaching the Carrying Handles

When carrying the monitor, attach the two supplied carrying handles to the monitor as shown below.
To attach the carrying handles, remove the existing screws from the monitor, and attach the handles with
the supplied screws. Keep the removed screws and return them to the original positions on the monitor
when the carrying handles are removed.
Handle attachment
Screw
Spacer
2 3
Hole for the
Power cord clamp
For the monitor in horizontal orientation
Attach the handles to the two positions on
the top of the monitor.
▼Rear view
Cable clamp positions
Handle attachment
Cable clamp
For the monitor in vertical orientation
Attach the handles to the two convenient
positions shown below.
▼Rear view
7
E