Table of Contents
Advertisement
How to install the monitor
Mounting precautions
• Since the monitor is heavy, consult your dealer before installation.
• Installing or moving the monitor must be done by two or more people.
• Do not hold the LCD panel when moving the monitor. This may cause product damage, failure, or injury.
• Install the monitor with the surface perpendicular to a level surface. If necessary, limit the tilt between
0 and 20 degrees downward.
• Mounting the monitor on the wall requires special expertise and the work must be performed by an
authorized SHARP dealer. You should never attempt to perform any of this work yourself. Our company
will bear no responsibility for accidents or injuries caused by improper mounting or mishandling.
• This monitor should be used at an ambient temperature between 0°C and 40°C. Provide enough space
around the monitor to prevent heat from accumulating inside.
For the monitor in horizontal
orientation
Front view
2[5]
• If it is difficult to provide such space because the monitor is installed inside a housing or for other
reasons, take other measures to keep the ambient temperature between 0°C and 40°C such as
installing a fan in the housing.
• When using the monitor in vertical orientation, be sure to orient the power LED to the bottom of the
monitor. Otherwise, a malfunction may result.
• Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a
malfunction.
• After mounting, it is recommended to take some measures to prevent the monitor from falling down.
• Do not place the monitor on a device which generates heat.
• Be sure to use a stand or a wall-mount/ceiling-mount bracket designed or designated for mounting the
monitor.
• This monitor is designed to be installed on a concrete wall/ceiling or pillar. Reinforced work might be
necessary for some materials such as plaster / thin plastic board / wood before starting installation.
This monitor and bracket must be installed on a wall which can endure at least 4 times or more the
weight of the monitor. Install by the most suitable method for the material and the structure.
• Use the supplied logo sticker when you install the monitor in vertical orientation.
* Do not remove the factory-affixed sticker but
affix the logo sticker over it.
Be careful not to cover the remote control
sensor or buttons.
10
E
Unit: inch[cm]
Side view
7-7/8[20]
2[5]
2[5]
For the monitor in vertical
orientation
Front view
2-3/4[7]
2[5]
The Power LED must be on the lower side.
*
INPUT
Unit: inch[cm]
Side view
7-7/8[20]
2[5]
2[5]
2-3/4[7]
Advertisement
Table of Contents
