Makita EB7660TH Instruction Manual page 15

Checking throttle valve
If the control cable is bent or caught, the throttle valve does not con-
proper idling. In such a case, reposition the control cable to ensure
proper valve movement.
1. Throttle valve 2.
4. Throttle valve stopper
If the throttle valve does not touch the throttle valve stopper even you
pull the throttle trigger fully or if the throttle valve does not touch the
follows:
1.
2. If the throttle valve does not touch the throttle valve stopper, turn
2
1. Fixing nut 2.
3.
Cleaning carburetor cover
valve, clean the carburetor cover as follows:
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like for cleaning the carburetor cover. Otherwise it may be
tarnished.
1. Pass a slotted screwdriver through the hole on the engine cover.
Release the clamp of the carburetor cover.
1
3 2
4
3. Control cable
1
15 ENGLISH
1
1. Carburetor cover
2. Clean the carburetor cover.
NOTICE:
Use wet clean cloth for cleaning the carburetor
cover.
3. Return the carburetor cover. Make sure the clamp of the carbure-
tor cover clicks when it is set in place.
Inspecting bolts, nuts and screws and other parts
Retighten loose bolts, nuts, etc.
Check for fuel and oil leakage.
Replace damaged parts with new ones for safety operation.
Cleaning engine, cooling air inlet
Keep engine clean by wiping down with a cloth rag.
down during operation, stop engine and inspect the air inlet vent for
any blockages. Clean it if necessary. Such a blockage may cause
overheat and damage the engine.
Replacing gaskets and packings
Replace gaskets and packings if the engine is disassembled.
described in this manual is only to be performed by Authorized
Service Agent.
Storage
WARNING:
When draining the fuel, stop the engine and
wait for the engine to cool down. Failure to do so may cause