Makita EB7660TH Instruction Manual page 13

3. Loosen the oil drain bolt to let the oil drain out. Be careful not to
allow oil to get on the fuel tank or other parts.
NOTICE:
Put the oil drain bolt in a location where it does not get dirt.
4. Remove the oil cap. (Removing the oil cap allows the oil to drain
easily.)
NOTICE:
Be sure to set the oil cap down in a location where it
does not get dirt.
5. As the level of the oil being drained decreases, tilt the blower
over on to the side with the drain so that the oil will completely drain
out.
6. After the oil has completely drained out, tighten the oil drain bolt
securely. If the bolt is not tightly fastened, it may result in oil leakage.
NOTICE:
back on when reattaching the drain plug.
7.
upper limit of the oil gauge.
1. Oil gauge 2. Upper limit mark 3. 100 ml level 4. Lower limit
mark
8.
leaks.
NOTICE:
Do not forget to put the oil cap gasket back on when
reattaching the oil cap.
Cleaning of air cleaner
WARNING:
INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection
Daily (every 10 operating hours)
Cleaning procedure
3
2
1
1. Knob bolts 2. Air cleaner cover 3. Element 4. Breather
1. Loosen the knob bolts.
2. Remove the air cleaner cover.
3.
a cloth or air blow. Replace the element with a new one if it is dam-
aged or very dirty.
NOTE: The element is a dry type and should not get wet. Never
wash with water.
4.
5.
6.
NOTICE:
dust adheres to it due to dusty environment.
NOTICE:
not cleared of oil, oil in the air cleaner may fall outside, result-
ing in oil contamination.
Checking the spark plug
running. Otherwise electrical shock may result.
"O" position.
aged or torn, replace it. Otherwise electrical shock may result.
1
NOTICE:
cylinder.
NOTICE:
down in order to avoid damaging the threaded hole in the
cylinder.
NOTICE:
hole. If installed at an angle, the threaded hole in the cylinder will
get damaged.
2
1.
3
4
2.
remove and install the spark plug.
4
13 ENGLISH
Remove the element and clean off any dirt from the element with
Wipe off any oil around the breather with a rag or cloth.
Install the element in the air cleaner case.
Attach the air cleaner cover and tighten the knob bolts.
Clean the element several times a day, if excessive
If operation continues with the element remaining
CAUTION:
Do not touch the spark plug while the engine is
CAUTION:
Set the stop control lever/stop switch to OFF
CAUTION:
Check the spark plug cord regularly. If it is dam-
When removing the spark plug, clean the spark plug
Remove the spark plug after the engine has cooled
Install the spark plug properly into the threaded
To open the plug cover, lift it and make a half turn of it.
1. Plug cover
Use the box wrench provided as an standard accessory to
1