Grizzly G0765 Owner's Manual page 40

Setting Spindle Speed Range
The high/low range lever shown in Figure 47,
is used to select one of the two spindle speed
ranges.
High/Low
Range Lever
Figure 47. High/low range lever set to low.
When the lever is moved to the right, as shown in
Figure 47, the low spindle speed range (100–1000
RPM) is selected. When the lever is moved to the
left, the high spindle speed range (100–2000)
RPM is selected.
Setting Spindle Direction & Speed
Set the spindle rotation direction to forward or
reverse with the spindle direction switch, shown
in Figure 48. Reset the Emergency Stop button,
press the ON button, then turn the variable speed
dial clockwise until the desired spindle speed dis-
plays on the spindle speed display.
Variable
Speed
Dial
Spindle
Direction
Switch
Figure 48. Spindle speed and direction controls.
-38-
Emergency Stop
Button
Spindle
Speed
Display
Configuration Example
Follow this example to gain a better understand-
ing of how to set the spindle speed.
To set spindle speed to 100 RPM:
1.
Make sure spindle is completely stopped,
and shift high/low range lever to LOW, as
shown in Figure 47.
Note: If high/low range lever does not eas-
ily adjust into position, rotate chuck by hand
while you apply pressure to lever. When
gears align, the lever will easily move into
place.
2. Turn variable speed dial to "0".
3. Turn spindle direction switch to "F", and
press ON button.
4. Adjust variable speed dial until spindle speed
display reads 100 RPM.
Model G0765 (Mfd. Since 5/15)