Chuck & Faceplate Mounting; Installation & Removal Device - Grizzly G0765 Owner's Manual

Chuck & Faceplate
Mounting
This lathe is equipped with an intrinsic backplate
spindle nose. With this type of spindle, a chuck or
faceplate is mounted directly to the backplate with
hex nuts.
Never use spindle speeds faster than chuck
RPM rating or safe limits of your workpiece.
This lathe ships with the 3-jaw chuck installed. Excessive spindle speeds greatly increase
This is a scroll-type chuck where all three jaws risk of workpiece or chuck being thrown
move in unison when the chuck key is used. from machine with deadly force!
The included 4-jaw chuck features independent
This lathe ships with the 3-jaw chuck installed.
jaws, which are used for square or unevenly-
This is a scroll-type chuck where all three jaws
shaped stock, and to mount work that needs to be
move in unison when the chuck key is used.
adjusted to near-zero total indicated runout.
The included 4-jaw chuck features independent
The included faceplate has slots for T-bolts that
jaws, which are used for square or unevenly-
hold standard or custom clamping hardware. With
shaped stock, and to mount work that needs to be
the correct clamping hardware, a faceplate offers
adjusted to near-zero total indicated runout.
a wide range of uses, including machining non-
concentric workpieces, straight turning between
The included faceplate has slots for T-bolts that
centers, off-center turning, and boring.
hold standard or custom clamping hardware. With
the correct clamping hardware, a faceplate offers
a wide range of uses, including machining non-
concentric workpieces, straight turning between
centers, off-center turning, and boring.
Model G0765 (Mfd. Since 5/15)
Installation &
Removal Device
Place a piece of plywood over the bedways to pro-
tect them from damage if a chuck or other tooling
is dropped (see below).
Plywood Protection
Plate for Chucks
Installed by Hand
Figure 18. Example of common device used
during chuck installation and removal.
-23-