Installing The Guard - Makita DUR364L Instruction Manual

Installing the grip
2
3
4
1. Grip 2. Hex bolt 3. Cover 4. Clamp 5. Hanger
Fit the grip onto the pipe and tighten it with two hex bolts.
Make sure that the grip is located further than the hanger.

Installing the guard

WARNING:
• Never use the tool without the guard illus-
trated in place. Failure to do so can cause
CAUTION:
cutting the nylon cord.
3
1. Cutter 2. Clamp 3. Bolt
3
1. Cutter 2. Clamp 3. Bolt
1
5
1
2
1
(The shape of the guard may differ from country to country.)
Align the clamp on the pipe with the protector. And
tighten them with bolts.
Installing nylon cutting head or
plastic blade (optional accessory)
CAUTION:
• If the nylon cutting head / plastic blade acci-
dentally impacts a rock or hard object during
operation, stop the tool and inspect for any
damage. If the nylon cutting head / plastic
blade is damaged, replace it immediately.
Use of a damaged cutting tool could result in
NOTICE:
• Be sure to use genuine Makita nylon cutting head
/ plastic blade.
Turn the tool upside down so that you can replace the
nylon cutting head easily.
2
1. Nylon cutting head 2. Metal guard 3. Receive
washer 4. Hex wrench 5. Tighten
1. Plastic blade 2. Metal guard 3. Receive washer
4. Hex wrench 5. Tighten
Insert the hex wrench through the hole on the motor
housing and rotate the receive washer until it is locked
with the hex wrench. Place the nylon cutting head /
plastic blade onto the threaded spindle directly and
tighten it by turning it clockwise. Remove the hex
wrench.
To remove the nylon cutting head / plastic blade, turn it
counterclockwise while holding the receive washer with
the hex wrench.
10 ENGLISH
1
4
1
4
5
2
3
5
2
3