Inventory - Grizzly G7944 Owner's Manual

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
A
B
C
E
Model G7943/G7944 (Mfd. Since 09/17)

Inventory

M
N
D
F
Figure 4. G7943/G7944 box inventory.
Description
A. Table ........................................................... 1
B. Table Support Assembly ............................ 1
C. Small Lock Lever ........................................ 1
D. Large Lock Lever ........................................ 1
E. Crank Lever ................................................ 1
F.
Crank Handle ............................................. 1
G. Column ....................................................... 1
H. Base ........................................................... 1
I. Lock Wrench .............................................. 1
J.
Downfeed Handles ..................................... 3
K. Arbor ........................................................... 1
L. Drift Key ...................................................... 1
M. Chuck Key .................................................. 1
N. Chuck ......................................................... 1
O. Headstock Assembly .................................. 1
P.
Hardware Bag (Not Shown) ........................ 1
—Belt Cover Knob ..................................... 1
—Hex Wrench 3mm ................................... 1
—Hex Wrench 5mm ................................... 1
—Hex Bolt M10-1.5 x 25mm....................... 4
O
L
K
G7943
G
G7944
J
I
H
Qty
-15-