Makita JR3070CT Technical Information page 9

R
epair
[3] -3. Disassembling/ Assembling Slider
DISASSEMBLING
7) While raising the end of bearing complete side, remove slider from slider support by pulling in the direction
of the arrow. (Fig. 19)
8) Remove X ring 14 from slider support. (Fig. 19)
Fig. 19
Bearing complete
Slider
ASSEMBLING
1) Install X ring 14 on slider support. (Refer to Fig. 19.)
2) Put bearing complete on the motor side-end of slider, and plane bearing 14A on the blade side-end of slider. (Fig. 20)
Important: Bearing complete and plane bearing 14A are both not reversible when assembled to slider.
Be sure to place them so that the rib on bearing complete/ plane bearing 14A faces toward the motor side.
Fig. 20
Motor side
Bearing complete
rib
3) Mount slider to slider support. (Refer to Fig. 19.)
4) Fasten plate A and plate B to slider support as illustrated to left in Fig. 21.
5) Mount compression spring 5 (2 pcs) to slider support as illustrated to right in Fig. 21.
Fig. 21
Slider support
Plate A securing
plane bearing 14A
Plane bearing 14A
Slider support
Slider block
Plate B securing
bearing complete
Blade side
Slider Plane bearing 14A
Compression spring 5
Slider support
P 9/ 15
X ring 14
rib