NEC UNIVERGE SV9100 Features And Specifications page 1055

Program
Program Name/Description
Number
Security Sensor Setup – Interval of Auto
20-46-11
Dial
Assign interval between Auto Dial when making
emergency call.
Security Sensor Setup – General Purpose
20-46-12
Relay Contact Detector Circuit Setup
Define general purpose relay contact detector
circuit number (programmed in Program 10-41)
for connect security sensor.
Time Pattern Setting for Watch Mode –
20-47-01
Watch Mode
Define watch mode on/off against time pattern
1 ~ 8.
Time Pattern for Security Sensor – Security
20-48-01
Sensor
Define security sensor on/off against time
pattern 1 ~ 8.
Delay Timer for Security Sensor – Sensor
20-55-01
Delay Timer
Assign the delay time, when the contact
detection start to work after set the security
sensor. The sensor starts at once in case of set
0.
SMDR Output Options – Security Auto
35-02-22
Dialing
Select whether the system should display the
SAD (Security Auto Dialing) on SMDR report.
SMDR Output Options – Watch Auto Dialing
35-02-23
Select whether the system should display the
WAD (Warning Auto Dialing) on SMDR report.
System Alarm Setup – Alarm Type
90-10-01
Set the alarm type 31, 32, 33. Alarm 31 – Auto
dialing after sensor detection.
Alarm 32 – Auto Dialing for Remote Watch
function.
Alarm 33 – Fail to auto dialing of security
function.
System Alarm Setup – Report
90-10-02
Assign whether or not the alarm information is
reported to the predefined destination in
Program 90-11.
Traffic Report Data Setup – Security Sensor
90-20-11
Dial Record
Assign whether or not the security sensor dial
report is recorded for Record Security sensor
dialing and Remote Inspection dialing.
Operation
Warning Message (Watch Mode)
< Program >
Input Data
Security Sensor No.
1 ~ 8
0 = No Call
1 ~ 3600 seconds
Security Sensor No.
1 ~ 8
0 = Not Used
1 ~ 8 = Detect Circuit Number
Time Pattern 1 ~ 8:
0 =Off
1 = On
Time Pattern 1 ~ 8:
0 =Off
1 = On
0 ~ 3600 seconds
SMDR Port 1 ~ 8:
0 = No Output
1 = Output
SMDR Port 1 ~ 8:
0 = No Output
1 = Output
0 = Not Set
1 = Major Alarm
2 = Minor Alarm
0 = No Report (no autodial)
1 = Report (autodial)
0 = Not Record
1 = Record
1055
Default
0
0
0
0
60
0
0
0
0
0