Cisco D9800 Configuration Manual page 20

Mapping the Program PIDs
• Front Panel (single-stream unit): from the D9800 front panel, choose Setup > Outputs > TS Out > DPM > ASI1,
ASI2, IP1/2,or IP3/4.
Step 2
Click the program entry radio button you want to map the PIDs and click Edit or choose the program entry from the PE
front panel menu.
Step 3 In the Output Channel # field, or the OutCh front panel menu, enter the output channel number you want to map to
the input channel (displayed in the Input Channel # field or the InCh front panel menu). This value is only used if the
PE Action is set to Map. You can enter a range from 1 to 65535.
Step 4 In the Output PMT PID field, or the second PMT front panel menu, enter the output PMT PID number you want to
map to the input PMT PID (displayed in the Input PMT PID field or the first PMT front panel menu). This value is
only used if the PE Action is set to Map. You can enter a range from 2 to 8190.
Step 5 For front panel only, choose the PID menu to map the program PIDs.
Step 6
You can click on the radio button of an existing PID mapping entry you want to modify or click the + button to insert a
new PID mapping. If there is no record available on the front panel, choose Yes to insert a new record.
The Input Stream, or the ITyp front panel menu, indicates the input service that will be mapped by the current entry.
The Input PID, or the PID front panel menu, displays the input PID (1 to 8190) that will be mapped by the current entry.
This is only used if Action is set to Map.
Step 7
From the Action drop-down list, or the Act front panel menu, choose the action to perform on the current PID. The Drop
action is always performed, but the Map option is only applied if the PE Action is Map and the Remapping Mode is Svc
ID & PID in the DPM General Settings section.
Option
Drop
Map
Step 8
If the Action, or the Act front panel menu, is set to Map, enter the output PID number (0 to 8192) in the Output PID
field, or the PID front panel menu.
Step 9 In the Stream Type field, or the StTyp front panel menu, enter a stream type to map within a PE to a specified PID (0
to 255).
Step 10 From the Category drop-down list, or the OTyp front panel menu, choose the service to configure. If an input service
matches this type and Instance, then the Action will be applied. This value is only used if Action is set to Map.
Step 11
In the Instance field, or the In front panel menu, enter the instance of the service specified by Category to configure (1
to 64). If an input service matches this type and instance, then the Action will be applied.
Step 12 Click Save, and then click OK.
Step 13
Apply the changes.
Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide
20
Description
The service selected by the Category and Instance will be mapped to the specified PID. This is
only applied if the PE action is Map and the Remapping Mode is Svc ID & PID.
The service selected by the Category and Instance will be removed from the PMT and the output
stream.
Configuring the Transport Stream Information