23 Protrusions on the nozzle band Slide switch 16 Adapter (required for some Dial application tools) Front lamp 17 Nozzle band SPECIFICATIONS Model DTM40 DTM50 –1 Oscillation per minute 6,000 – 20,000 (min Oscillation angle, left/right 1.6° (3.2° total) Overall length 324 mm...
Page 6
11. Do not touch the application tool or the work- WARNING: piece immediately after operation; they may be DO NOT let comfort or familiarity with product extremely hot and could burn your skin. (gained from repeated use) replace strict adherence 12.
FUNCTIONAL DESCRIPTION Indicating the remaining battery capacity (Fig. 3) (Only for battery cartridges with “B” at the end of the WARNING: model number.) • Always be sure that the tool is switched off and Press the check button on the battery cartridge to indi- battery cartridge is removed before adjusting or cate the remaining battery capacity.
When not in use, store the hex wrench as shown in the carbon brush inspection and replacement, any other figure to keep it from being lost. maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
The vibration total value (tri-axial vector sum) determined CAUTION: according to EN60745: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. Work mode: Sanding The use of any other accessories or attachments might or less Vibration emission (a ): 2.5 m/s...
Page 10
ENH101-18 For European countries only EC Declaration of Conformity Makita declares that the following Machine(s): Designation of Machine: Cordless Multi Tool Model No./ Type: DTM40, DTM50 Conforms to the following European Directives: 2006/42/EC They are manufactured in accordance with the following...