Configuring General Email Options - Cisco cBR-8 Configuration And Troubleshooting Manual

Call Home
Command or Action
Step 4
[no | default ] add-command command string
Example:
Device(cfg-call-home-snapshot)#
"show version"
Step 5 end
Example:
Device(cfg-call-home-snapshot)#

Configuring General Email Options

Configuring the Mail Server
To use the email message transport, you must configure at least one Simple Mail Transfer Protocol (SMTP)
email server address. You can specify up to four backup email servers, for a maximum of five total mail-server
definitions.
Consider the following guidelines when configuring the mail server:
• Backup email servers can be defined by repeating the mail-server command using different priority
• The mail-server priority number parameter can be configured from 1 to 100. The server with the highest
To configure general email options, perform the following steps:
SUMMARY STEPS
1. configure terminal
2. call-home
3. mail-server {ipv4-address | name} priority number
4. sender from email-address
5. sender reply-to email-address
6. source-interface interface-name
7. source-ip-address ipv4/ipv6 address
8. vrfvrf-name
add-command
exit
numbers.
priority (lowest priority number) is tried first.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
Purpose
Adds the command to the Snapshot alert group. The no or
default command removes the corresponding command.
• command string—Cisco IOS command. Maximum
length is 128.
Exits and saves the configuration.
for Cisco IOS XE Fuji 16.8.x
Configuring Call Home
19