Cisco cBR-8 Configuration And Troubleshooting Manual page 148

Enabling Usage-based Billing Feature File Mode Using CLI Commands
Command or Action
Step 2
configure terminal
Example:
Router# configure terminal
Example:
Router(config)#
Step 3 cable metering filesystem filesys [flow-aggregate]
[cpe-list-suppress] [full-records]
Example:
Router(config)# cable metering filesystem
harddisk:
Example:
Router(config)#
Step 4 snmp-server enable traps cable metering
Example:
Router(config)# snmp-server enable traps cable
metering
Example:
Router(config)#
Step 5 cable sflog max-entry number entry-duration time
Example:
Router(config)# cable sflog max-entry 2000
entry-duration 7200
Example:
Router(config)#
Step 6 cable metering source-interface interface
Example:
Router(config)# cable metering source-interface
loopback100
Example:
Router(config)#
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
136
Purpose
Enters global configuration mode.
Enables the Usage-based Billing feature for file mode and
configures it.
The system will write the billing records on this file system
using a file name that contains the hostname of the router
followed by a timestamp when the record was written.
(Optional) Enables SNMP traps for usage-based billing events.
Traps are sent when a new billing record is available, or when
the system encountered a failure (such as insufficient disk
space) in writing the new billing record.
(Optional) Enables logging for deleted SNMP service flows,
which allows the billing feature to include information about
deleted service flows.
(Optional) Enables specification of the source-interface for
the billing packets, usually a loopback interface.
Usage-Based Billing (SAMIS)