User Info Select - Omega HHP360 Series User Manual

User Info Select

The User Info Select registers are designed to provide the user with
information on the hardware and software in the manometer. This
register provides read only information on the sensor's serial
number, software version and date of manufacture. It also allows
the user to edit the Auto Shut-Off, Lockout and Start-Up Header
Name features.
To access the User Info Select registers, follow the steps below. To
configure a User Info Select register, follow the steps shown on the
following page.
Keystroke
1. From the Measure
Mode press the PRGM
key.
2. Press the  arrow key
twice
3. Press the PRGM key.
4. Press the  arrow key.
5. Press the  arrow key.
6. Press the  arrow key.
Instructions to set
AUTO SHUT-OFF are
in this manual.
7. Press the  arrow key.
See instructions for
using LOCKOUT later
in this manual.
8. Press the  arrow key.
Instructions for editing
the Header later in this
manual.
9. Press the  arrow key
to go back to "USER
INFO SELECT"
screen.
20 of 36
Display
Top line reads "PROGRAM
MODE" and bottom line reads
"UNITS SELECT".
Bottom line changes to "USER
INFO SELECT".
Bottom line shows serial
number.
Software version number
shown.
Manufacture date shown.
Top line reads "AUTO SHUT
OFF" and bottom line reads
"ENTER TO SELECT".
Top line reads "LOCKOUT
CODE" and bottom line reads
"ENTER TO SELECT".
Top line reads "HEADER
NAME" and bottom line reads
"text". The cursor flashes at
bottom left.
Top line reads "PROGRAM
MODE" and bottom line reads
"USER INFO SELECT".