Display User Defined Altitude - Omega HHP360 Series User Manual

Display User Defined Altitude

User Defined Altitude is useful in determining elevation change
from a map elevation reference or from a survey trig marker
elevation. To set up the HHP360 to display altitude based on user
entered information, use the following steps:
Keystroke
1. Press the PRGM key.
2. Press the PRGM key.
3. Press the ▲or ▼arrow
key until "FEET" or
"METERS" is
displayed.
4. Press the PRGM key.
5. Press the ▲ arrow key
once.
6. Press the PRGM key.
7. If the value shown in
step 6 is the correct
altitude, press the
PRGM key to accept
and the ◄ key to return
to Measure Mode.
- OR -
If the value shown in
step 6 is not the correct
altitude, press the ▼ key
8. Press the PRGM key.
Example: set altitude to
685 feet above sea level.
15 of 36
Display
Top line reads "PROGRAM
MODE" and bottom line reads
"UNITS SELECT".
Top line reads "UNITS
SELECT" and bottom line
shows current engineering
unit.
Top line reads "UNITS
SELECT"
Bottom line reads "FEET or
METERS".
Top line reads "ALTITUDE
SELECT". Bottom line reads
"STANDARD".
Top line reads "ALTITUDE
SELECT". Bottom line reads
"REF. TO USER".
Top line reads "VALUE=:
00000000". Bottom line reads
"CHANGE?: NO".
Top line reads "PROGRAM
MODE" and bottom line reads
"UNITS SELECT".
Top line reads "VALUE=:
00000000". Bottom line reads
"CHANGE?: YES".
Top line reads "USER MODE-
FEET". Bottom line reads
"00000000".