Cisco DMP 4305G Getting Started Manual page 56

FAQs
Splash Screen FAQs
Q. Can I add my own logo to the DMP splash screen or change its design in any other way?
A.
Q. Can I change the splash screen duration?
A.
Wireless Connectivity FAQs
Q. Can I use a wireless DMP model as an access point for other devices?
A.
Q. Which IP address is active on my DMP when its Ethernet and 802.11 interfaces are both connected?
A.
Q. Does a DMP 4305G support Wi-Fi?
A.
Q. Does a DMP 4310G support Wi-Fi?
A.
Q. What might prevent my DMP from receiving an IP address on a wireless network?
A.
Touchscreen FAQs
Q. What can cause a properly calibrated touchscreen to operate as if it is not calibrated?
A.
Getting Started Guide for Cisco Digital Media Players
56
No, not in this release. (Its information and design are in DMP firmware.)
Yes. See Edit the Splash Screen Duration to Obscure the DMP IP Address, page
No, not in this release.
Ethernet connections take priority over Wi-Fi connections on DMPs where both are active.
No.
No.
These are among the possible reasons.
The Broadcast SSID setting must be enabled on your wireless access points. Is it enabled?
•
You must reconfigure your wireless DMPs whenever you change SSID settings in your WLAN.
•
Did you forget to do this?
Some WLAN administrators enforce a security policy that restricts DHCP address assignments
•
to known MAC addresses. Does your administrator do this?
Is your WLAN working correctly?
•
Do any network address translation settings for your DMP differ from NAT behaviors in
•
your network?
If this happens to you, unplug the serial cable (or USB cable) that connects this touchscreen to
your DMP. Then, plug that cable back in again.
43.
78-19212-02