Cisco DMP 4305G Getting Started Manual page 30

Configure Settings
Respond to the prompt. It sometimes varies.
Step 3
•
•
Stop. Remain logged in. You have completed this procedure.
Step 4
Related Topics
•
Establish a Wireless Network Connection
Timesaver Complete this optional procedure at your discretion.
Before You Begin
•
•
•
•
•
•
•
Getting Started Guide for Cisco Digital Media Players
30
Does it ask you to EDIT a password before you can log in?
The first time that you start DMPDM, it prompts you to change its factory-defined master
password. You will never see this prompt again, unless you restore your DMP to its
factory-default settings.
Enter a new master password that contains at least eight characters, which combine uppercase
a.
and lowercase letters with numerals
Click Activate.
b.
Does it ask you to ENTER a password so that you can log in?
Use the login name admin.
a.
Use whichever master password you saved most recently.
b.
Protect Your DMP from Unauthorized Management
Do the hardware and firmware for your DMP support wireless networking? DMP 4305G and
DMP 4310G endpoints do not.
To verify whether you must use an Ethernet cable, see
–
– Alternatively, if Table 2
http://cisco.com/go/dms/dmp/datasheets.
The Broadcast SSID setting must be enabled on your wireless access points (also known as wireless
routers or WLAN controllers). Otherwise, your DMPs cannot connect to your WLAN and are
prevented from obtaining IP addresses.
We do not support "open" wireless networks. They are a security risk.
Does a security policy in your network restrict DHCP address assignments to known MAC
addresses? If so, locate the WLAN address printed on a sticker that is affixed to your DMP. Then,
share this address with your security policy administrator.
Verify that your wireless network is working correctly, is available, and you understand how it
authenticates connection requests.
Establish an Ethernet Connection.
Log in to DMPDM.
does not describe your DMP model, see its datasheet at
Table 2 on page 12.
78-19212-02