Cisco DMP 4305G Getting Started Manual page 16

Connect Equipment
Connect to a 100V–240V AC Socket
Warning Use ONLY the power adapter, power cord, and plugs that we supply for your DMP model explicitly.
DO NOT USE OTHERS, even if they appear identical or appear to work with another DMP model.
Before You Begin
•
•
Procedure
Does your DMP power cord require assembly? If so, assemble it.
Step 1
a.
b.
Connect the DMP power cable to the AC adapter.
Step 2
Step 3 Connect the DC barrel connector to the DC power supply on the DMP chassis.
Step 4 Connect to an AC electrical outlet that you know is grounded. It must use the correct voltage level for
your locale. Supported levels range from 100V to 240V.
Note
Step 5 Stop. You have completed this procedure.
Related Topics
•
•
•
Use 802.3af Power over Ethernet (PoE)
Note •
•
•
Getting Started Guide for Cisco Digital Media Players
16
Did your Cisco equipment ship with a power cord and AC adapter? Or did it ship with an AC adapter
and multiple, snap-on plugs? Your packing list states which supplies Cisco planned to ship.
(Alternatively, you might have purchased a Cisco power cord and AC adapter as accessories for your
equipment.)
To learn which Cisco power cords and AC adapters are compatible with your DMP, see its datasheet
at http://www.cisco.com/go/dms/dmp/datasheets.
Identify the correct snap-on plug for your region.
Snap that plug onto the AC adapter.
To protect your DMP from electrical surges, we recommend that you use a surge protector or an
uninterruptable power supply from a reputable manufacturer.
Physical Interfaces (I/O Ports), page 12
DMP Power Cord Options, page 14
Use 802.3af Power over Ethernet (PoE), page 16
You can power a DMP 4310G through its Ethernet cable. Other DMP models do not support this feature.
A DMP 4310G has two USB interfaces on its chassis. When you use PoE to power a DMP 4310G, we recommend that
you use no more than one of these USB interfaces at a time. IEEE 802.3af PoE is limited in its capacity and might not be
sufficient to power your DMP and two USB peripherals simultaneously.
When both PoE power and AC power are detected, AC power overrides PoE and disconnects the PoE circuit.
78-19212-02