Table of Contents
Advertisement
Your presentation system should show a Cisco logo and should show the IP address for your DMP.
Tip
Click Save Configuration in the Administration list, and then click Save.
Step 7
Step 8
Stop. You have completed this procedure.
Related Topics
•
Choose and Calibrate a Touchscreen Driver
This procedure applies to you only when your DMP supports interactivity through touch and your
presentation system is a touchscreen. Furthermore, it assumes that you completed the
Touchscreen" section on page
Before You Begin
•
•
•
Procedure
Does your touchscreen show a message that says it must download a "characterization" file?
Step 1
•
•
Step 2
Because some touchscreen drivers cannot be calibrated on a DMP while it is playing video, use DMPDM
to stop all videos.
a.
b.
Choose the browser rotation angle for your touchscreen.
Step 3
Supported rotation angles are 0°, 90°, 180°, and 270°.
78-19212-02
Later, you can change how long this splash screen is visible during startup. See the
Duration to Obscure the DMP IP Address" section on page
Physical Interfaces (I/O Ports), page 12
Do the hardware and firmware for your DMP support touchscreen technologies? DMP 4305G and
DMP 4310G endpoints do not.
Do we support the touchscreen brand, model, and device driver that you will use? See
http://www.cisco.com/go/dms/compatibility.
Log in to
DMPDM.
If so:
–
Do not disturb or interrupt this process. It occurs only once, automatically.
–
The process takes approximately 10 minutes to finish. When it is finished, your touchscreen will
clear the message automatically.
–
Stop. You have completed this procedure and there is no need to perform any of its other steps.
Otherwise, go to Step 2.
Click Video Multicast in the Display Actions list, and then click Stop.
Click Media URL in the Display Actions list, and then click Stop.
43.
27.
Getting Started Guide for Cisco Digital Media Players
Configure Settings
"Edit the Splash Screen
"Connect to a
37
Hide quick links:
Advertisement
Chapters
Table of Contents
