Cisco DMP 4305G Getting Started Manual page 18

Connect Equipment
Establish an Ethernet Connection
Before You Begin
•
•
Procedure
Plug one end of a standard Ethernet cable into the corresponding interface on your DMP.
Step 1
Plug the other end of this cable into a network hub, network switch, or router whose network uses DHCP
Step 2
to allocate IP addresses dynamically.
Stop. You have completed this procedure.
Step 3
Related Topics
•
•
Wireless Connection Concepts
•
•
•
Glossary
Go to terms that start with... [
Timesaver
numerals
A wireless networking standard that specifies a maximum data transfer rate of 11Mbps and an operating
802.11b
frequency of 2.4GHz.
A wireless networking standard that specifies a maximum data transfer rate of 54Mbps, an operating
802.11g
frequency of 2.4GHz, and backward compatibility with 802.11b devices.
Getting Started Guide for Cisco Digital Media Players
18
Does a security policy in your network restrict DHCP address assignments to known MAC
addresses? If so, locate the MAC address printed on a sticker that is affixed to your DMP. Then,
share this address with your security policy administrator.
Does your DMP support wireless networking? If so, consider whether you might prefer to use that
method instead of this one.
Physical Interfaces (I/O Ports), page 12
Wireless (802.11 b/g) Connection Procedures, page 22
Glossary, page 18
Workflow, page 21
Understand WEP Keys and Passphrases, page 21
| | |
numerals A C E
| | | | ].
P S T W
78-19212-02