Grizzly G4003G Owner's Manual page 28

5. Select spindle speed of 70 RPM by mov-
ing spindle speed levers to B and
Figure 22).
Speed Levers
Alpha
Lever
Set to "B"
Figure 22. Spindle speed set to 70 RPM.
6. Push POWER START button, then move
spindle lever (see Figure 20) down to start
spindle forward rotation. The top of chuck
should turn down and toward front of lathe.
— When operating correctly, the machine will
run smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
-26-
7.
I
(see
Numeric
8.
Lever
Set to "I"
Congratulations! The test run is complete. Perform
the following Spindle Break-In procedure.
Push Emergency Stop/RESET button to turn
lathe OFF, then, without resetting Emergency
Stop/RESET button, try to restart spindle
rotation, as instructed in Step 8. Spindle
should not start.
— If spindle rotation does start with RESET
button pressed in, the RESET button
safety is not operating correctly. This
safety feature must operate properly before
continuing operation. Use spindle lever to
stop lathe, disconnect it from power, and
call Tech Support for help.
Move spindle lever to OFF (center) position,
and reset Emergency Stop/RESET button by
twisting it clockwise until it pops out.
Model G4003G (Mfd. Since 1/15)