Test Run - Grizzly G4003G Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Model G4003G (Mfd. Since 1/15)
To test run your machine:
1. Make sure that chuck and jaws, if installed,
are secure (refer to Chuck Installation on
Page 30).
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test.
2.
Make sure spindle lever is in OFF (center)
position (see Figure 21).
Half-Nut Lever
is Pulled Up
(Disengaged)
Feed Selection
Lever is
Horizontal
(Disengaged)
Cross Slide
Disengaged
Carriage
Feed Selection
Lever
Figure 21. Disengaging carriage components.
3. To ensure carriage components do not unex-
pectedly move during following steps, disen-
gage half nut lever and apron feed selection
lever (see Figure 21).
4. Rotate Emergency Stop/RESET button clock-
wise so it pops out. The power lamp on con-
trol panel should illuminate.
Spindle Lever
(OFF, Center
Position)
Disengaged
Halfnut
Lever
Engaged
-25-