Grizzly G4003G Owner's Manual page 23

14. Remove headstock end cover to gain better
access to the headstock base pedestal (see
Figure 15).
Headstock Pedestal
Mounting Points
Figure 15. End cover removed to expose
headstock pedestal mounting points.
15. Make sure lathe bedway is level side to side
and front to back and, if necessary, shim
between lathe pedestals and chip pan (refer
to Leveling on Page 22 for detailed informa-
tion).
16. Insert (6) M12-1.75 x 40 hex bolts with (6)
6mm flat washers through pedestals and chip
pan, then thread them into cabinet tops.
Note: For best results, recheck the ways in
24 hours to make sure they are still level and
have not twisted. Reshim as required.
Model G4003G (Mfd. Since 1/15)
17. Apply a bead of silicone around each of the
base pedestals where they contact chip tray,
to further reduce possibility of fluids leaking
into cabinets.
18. Attach back splash to rear of lathe with (4)
M6-1 x 10 Phillips head screws and (4) 6mm
flat washers, as shown in Figure 16.
x 4
Figure 16. Locations to secure back splash.
-21-