Verifying Vxlan Bgp Evpn And Otv Interoperation, And Otv With Bdi; Display Vxlan Configuration On The Border Leaf Switch Bl1 - Cisco Nexus 7000 Series Configuration Manual

Verifying VXLAN BGP EVPN and OTV Interoperation, and OTV with BDI

• In an OTV with BDI single box solution, the otv suppress-arp-nd option is not supported in the Cisco
• For OTV overlays, only Generic Routing Encapsulation (GRE) encapsulation is supported for the 8.2(1)
Step 2 Similarly, enable OTV configurations on OTV2.
Step 3 Configure vPC function on OTV1 and OTV2
vPC Peer 1 (OTV1) configuration
OTV1(config)# interface Bdi3500
vPC Peer 1 (OTV2) configuration
OTV1(config)# interface Bdi3500
• The primary, unique IP address (209.165.201.10 for vPC peer 1 switch [OTV1], and 209.165.201.12
Verifying VXLAN BGP EVPN and OTV Interoperation, and OTV
with BDI
Verify VXLAN and OTV configurations on BL1:

Display VXLAN Configuration on the Border Leaf Switch BL1

In the following example, you can see the VXLAN overlay information such as the loopback interface
information, and the state of the overlay. For vPC switches, primary and secondary IP addresses are configured:
BL1# show nve interface
Interface: nve1, State: Up, encapsulation: VXLAN
VPC Capability: VPC-VIP-Only [not-notified]
Local Router MAC: 1005.caf4.cdd9
Cisco Nexus 7000 Series NX-OS VXLAN Configuration Guide
124
At least one interface should be present where the VNI is up. On a OTV with BDI pod, the VNI can be
brought up on a VSI interface, using an encapsulation profile, as shown in the example. If the otv
site-vlan configuration is enabled, then you need to remove it before configuring the otv site-vni
command.
NX-OS 8.2(1) release.
release.
no shutdown
vrf member cust1
no ip redirects
ip address 209.165.201.10/24
ip address 209.165.201.20/24 secondary anycast-primary
fabric forwarding mode anycast-gateway
no shutdown
vrf member cust1
no ip redirects
ip address 209.165.201.12/24
ip address 209.165.201.20/24 secondary anycast-primary
fabric forwarding mode anycast-gateway
for vPC peer 2 switch [OTV2]) is created for ARP requests over OTV. The common, secondary anycast
gateway IP address (209.165.201.20) is used as a Layer 3 gateway for traffic, including ARP requests,
from the specified bridge domain Bdi3500 within the datacenter.
VXLAN BGP EVPN and OTV Interoperation