How To Configure Campus Fabric Interconnect-Mpls L3Vpn; Feature Set Configuration; Campus Fabric Configuration - Cisco Nexus 7000 Series Configuration Manual

How to Configure Campus Fabric Interconnect—MPLS L3VPN
How to Configure Campus Fabric Interconnect—MPLS L3VPN
• Type the switch# configure terminal command to enter global configuration mode (config)#
Note
• Since the focus of this feature is the fabric interconnect function, ensure that the campus fabric is
• The example is for PxTR 1 configurations. However, configurations have to be implemented on

Feature Set Configuration

Configure MPLS L3VPN, BGP, LDP, LISP and VXLAN features:
PxTR 1(config)# feature-set mpls
• Some configurations, such as LISP and VXLAN features, are already enabled for campus fabric

Campus Fabric Configuration

Step 1 Configure VXLAN related commands
Create a bridge domain and associate the corresponding Layer 3 VNI:
PxTR 1(config)#
Add the Layer 3 virtual routing and forwarding (VRF) VNI to the VXLAN overlay network and enable
LISP reachability:
PxTR 1(config)# interface nve1
Step 2 Configure LISP related commands
Configure LISP parameters and route distinguisher and route target functions for the vrf6000 VRF:
PxTR 1(config)# vrf context vrf6000
Cisco Nexus 7000 Series NX-OS VXLAN Configuration Guide
92
functional, and LISP, VXLAN and other configurations are enabled.
PxTR 1, PxTR 2, and PxTR 3 for traffic flow across fabrics.
feature-set fabric
feature bgp
feature lisp
feature mpls l3vpn
feature mpls ldp
feature nv overlay
feature vni
configuration. They are noted here for completeness.
vni 6000
system bridge-domain 300
bridge-domain 300
member vni 6000
no shutdown
host-reachability protocol lisp
source-interface loopback0
member vni 6000 associate-vrf
Campus Fabric Interconnect - MPLS L3VPN