Introduction; Message Length - Honeywell 3200 User Manual

6
Symbologies

Introduction

This programming section contains the following menu selections. Refer to
Chapter 9
• All Symbologies
• China Post Code
• Codabar
• Code 11
• Code 39
• Code 32 Pharmaceutical (PARAF)
• Code 93
• Code 128
• UPC-A/EAN-13 with Extended
Coupon Code
• EAN/JAN 8
All Symbologies
If you want to decode all the symbologies allowable for your imager, scan the All
Symbologies On code. If on the other hand, you want to decode only a
particular symbology, scan All Symbologies Off followed by the On symbol for
that particular symbology.
All Symbologies On

Message Length

You are able to set the valid reading length of some of the barcode symbologies.
If the data length of the scanned barcode doesn't match the valid reading length,
the imager will issue an error beep. You may wish to set the same value for
minimum and maximum length to force the imager to read fixed length barcode
data. This helps reduce the chances of a misread.
3200 User's Guide
for settings and defaults.
• Interleaved 2 of 5
• Matrix 2 of 5
• MSI
• Plessey Code
• RSS-14
• Straight 2 of 5 IATA
(two-bar start/stop)
• Straight 2 of 5
Industrial (three-bar
start/stop)
• Telepen
• UPC A
• UPC E
All Symbologies Off
6 - 1