Connecting The Imager With Usb; Usb Pc Or Macintosh Keyboard - Honeywell 3200 User Manual

Connecting the Imager with USB

Note: Honeywell recommends connecting the imager end of the cable first and
the host end second.
An imager can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the imager and to the computer.
2. The imager beeps.
3. Verify the imager operation by scanning a barcode from the Sample
Symbols in the back of this manual.
For additional USB programming and technical information, refer to the
Honeywell "USB Application Note," available at www.honeywellaidc.com.

USB PC or Macintosh Keyboard

The 3200 linear imagers are factory programmed for a USB interface. If this is
your interface and you do not need to modify the settings, skip to Chapter 3.
If you programmed the imager for a different terminal interface and you want to
change to a USB Keyboard (PC) or USB Keyboard (Mac), scan one of the
following codes to program the 3200 linear imager. Scanning these codes adds
a CR and selects the terminal ID (USB PC Keyboard - 124, USB Macintosh
Keyboard - 125).
USB Keyboard (PC)
USB Keyboard (Mac)
1 - 2 3200 User's Guide