Reading Techniques; Resetting The Standard Product Defaults - Honeywell 3200 User Manual

Reading Techniques

The imager has a bright red aiming beam that corresponds to its horizontal field
of view. The aiming beam should be centered horizontally over the barcode; it
will not read if the aiming beam is in any other direction.
Good Technique
Bad Technique
The best focus point for reading most code densities is about 5 inches (12.7 cm)
from the unit. To read a single barcode or multiple barcodes (on a page or on
an object), hold the imager at an appropriate distance from the target, pull the
trigger, and center the aiming beam on the barcode.

Resetting the Standard Product Defaults

If you aren't sure what programming options are in your imager, or you've
changed some options and want the factory settings restored, scan the
Standard Product Default Settings barcode below.
The Menu Commands
each of the commands (indicated by an asterisk (*) on the programming pages).
1 - 6
Standard Product Default Settings
starting on page 9-1
Bad Technique
lists the factory default settings for
3200 User's Guide