Power Connection; Test Run - Grizzly T10828 Owner's Manual

Power Connection

After you have completed all previous
setup instructions, the machine is ready to
be connected to the power supply.
To avoid unexpected startups or property
damage, use the following steps whenever
connecting or disconnecting the machine.
Connecting Power
1. Turn machine power switch OFF.
2. Insert power cord plug into a matching
power supply receptacle. Tool is now
connected to power source.
Figure 3. Connecting power.
Disconnecting Power
1. Turn machine power switch OFF.
2. Grasp molded plug and pull it com-
pletely out of receptacle. Do not pull
by the cord as this may damage wires
inside.
Figure 4. Disconnecting power.
Model T10828 (Mfd. since 12/14)
Serious injury or death can result
from using this machine BEFORE
understanding its controls and
related safety information. DO NOT
operate, or allow others to oper-
ate, machine until the information is
understood.

Test Run

To test run machine:
1. Clear all setup tools away from
machine.
2. Remove collet nut and collet.
3. Set variable-speed knob to lowest set-
ting.
4. Connect machine to power supply.
5. Turn machine ON, verify motor opera-
tion, and then turn machine OFF.
Tool should run smoothly and without
unusual problems or noises.
-7
-