Table Travel - Grizzly G0773 Owner's Manual

Tilting Headstock
Tool Needed
Wrench 36mm ................................................... 1
To tilt headstock:
1.
DISCONNECT MACHINE FROM POWER!
2.
Support headstock with one hand, then loos-
en headstock center bolt and angle lock nut
(see Figure 86).
Figure 86. Headstock tilt controls.
3. While viewing tilt scale, rotate headstock to
required angle, then retighten center bolt and
angle lock nut to secure headstock.

Table Travel

The cross slide table travels in two directions, as
illustrated in Figure 87:
• X-axis (longitudinal)
• Y-axis (cross)
X-Axis or Longitudinal Travel (Left & Right)
Figure 87. Possible directions of cross slide
travel.
Model G0773 (Mfd. Since 4/17)
Qty
Angle Lock
Nut
Y-Axis or
Cross Travel
(In & Out)
These movements are controlled by the car-
riage handwheel and cross slide handwheel (see
Figure 88).
Figure 88. Table travel controls.
Carriage Handwheel (X-Axis)
Graduated Dial
Increments ................................... 0.01" (0.25mm)
One Full Revolution .......................... 1" (25.4mm)
Use the carriage handwheel to move the carriage
left or right along the bed. Adjust the position of
the graduated scale by holding the handwheel
with one hand and turning the dial with the other.
Cross Slide Handwheel (Y-Axis)
Graduated Dial
Increments ............................... 0.001" (0.025mm)
One Full Revolution .....................0.08" (2.03mm)
Use this handwheel to move the cross slide table
toward or away from the tooling. The cross slide
handwheel has an indirect-read graduated dial,
which shows the actual distance the table moves.
Cross Slide
Table
Cross Slide
Handwheel
(Y-Axis)
Carriage
Handwheel
(X-Axis)
-53-