Makita GA4040C Instruction Manual page 9

For tool with locking screw type
wheel guard
1
2
1. Wheel guard 2. Bearing box 3. Screw
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard around 180° coun-
terclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
For tool with clamp lever type wheel
guard
1. Wheel guard 2. Bearing box 3. Screw 4. Lever
ing the screw. Mount the wheel guard with the protru-
sions on the wheel guard band aligned with the notches
on the bearing box. Then rotate the wheel guard around
180°.
1
1. Screw 2. Lever
3
1
2
3
4
-
2
9 ENGLISH
Tighten the wheel guard with fastening the screw after
pulling lever in the direction of the arrow. The setting
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing or removing depressed
accessory)
WARNING:
so that the closed side of the guard always
points toward the operator.
1. Lock nut 2. Depressed center wheel 3. Inner
spindle.
1
2
1. Lock nut wrench 2. Shaft lock
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the wheel, follow the installation procedure
in reverse.
1
2
3