Cutting Capacity; Operation; Securing Workpiece - Makita M2401 Instruction Manual

To install the wheel, follow the removal procedures in
reverse. Make sure to it the hole of cut-off wheel to the
ring and return the safety guard.
Hex wrench storage
► 1 . Hex wrench
When not in use, store the hex wrench as shown in the
igure to keep it from being lost.

OPERATION

CAUTION:
Proper handle pressure during
cutting and maximum cutting eficiency can
be determined by the amount of sparks that is
produced while cutting. Do not force the cut
by applying excessive pressure on the handle.
Reduced cutting eficiency, premature wheel wear, as
well as, possible damage to the tool, cut-off wheel or
workpiece may result.
Hold the handle irmly. Switch on the tool and wait until
the wheel attains full speed before lowering gently
into the cut. When the wheel contacts the workpiece,
gradually bear down on the handle to perform the cut.
When the cut is completed, switch off the tool and wait
until the wheel has come to a complete stop before
returning the handle to the fully elevated position.

Cutting capacity

Maximum cutting capacity varies depending on the
cutting angle and workpiece shape.
Max. cutting capacity with a brand-new cut-off
wheel
Cutting angle /
Workpiece shape
1

Securing workpiece

CAUTION:
the shaft threads when securing the workpiece.
Failure to do so may result in insuficient securing of
the workpiece. This could cause the workpiece to be
ejected or cause a dangerous breakage of the wheel.
While the thread holder is lifted, the vise plate can be
moved in and out quickly. To grip a workpiece, push the
handle until the vise plate contacts the workpiece then
return the thread holder. Turn the handle clockwise until
the workpiece is securely retained.
► 1 . Handle 2. Thread holder 3. Vise plate
When the cut-off wheel has worn down considerably,
place a spacer block behind the workpiece as shown
in the igure. You can more eficiently utilize the worn
wheel by using the mid point on the periphery of the
wheel to cut the workpiece. Use a sturdy and non-lam-
mable material for a spacer block.
8 ENGLISH
90°
127 mm
102 x 194 mm
70 x 233 mm
119 x 119 mm
137 x 137 x 10 mm
Always place the thread holder on
3
2
1
45°
127 mm
115 x 103 mm
106 x 106 mm
100 x 100 x 10 mm