Functional Description; Switch Action - Makita M2401 Instruction Manual

FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Unlocking/locking tool head
The tool head can be locked.
When using, unhook the lock chain from the hook. When not
in use or carrying, always hook the lock chain to the hook.
► 1 . Hook 2. Lock chain

Switch action

WARNING:
Before plugging in the tool,
always check to see that the switch trigger actu-
ates properly and returns to the "OFF" position
when released.
1
2
► 1 . Lock button / Lock-off button 2. Switch trigger
For tool with lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation,
pull the switch trigger, push in the lock button and then
release the switch trigger. To stop the tool from the
locked position, pull the trigger fully, then release it.
CAUTION:
Switch can be locked in "ON" posi-
tion for ease of operator comfort during extended
use. Apply caution when locking tool in "ON"
position and maintain irm grasp on tool.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
you simply pull the switch trigger without press-
ing the lock-off button. A switch in need of repair
may result in unintentional operation and serious
personal injury. Return tool to a Makita service center
for proper repairs BEFORE further usage.
NOTICE:
without pressing in the lock-off button. This can
cause switch breakage.
1
Interval between vise and guide
plate
2
CAUTION:
between the vise and the guide plate, make
sure that the guide plate is properly secured.
Insuficient ixing may result in personal injury.
CAUTION:
may not be secured safely when using the two,
wider interval settings.
The following interval settings of the vise are available:
• 0 - 170 mm (original setting)
• 35 - 205 mm
• 70 - 240 mm
If your work requires different setting, proceed as fol-
lows to change the spacing or interval.
Remove the two hex socket bolts using a hex wrench.
Move the guide plate to the desired position and secure
it with the hex socket bolts.
► 1 . Hex wrench 2. Guide plate 3. Hex socket bolts
6 ENGLISH
NEVER defeat the lock-off button
NEVER use the tool if it runs when
Do not pull the switch trigger hard
After adjusting the interval
Remember that narrow workpieces
1
3
2