6.2
Replacing Antenna
Tools required
•
T-15 Security TORX Screwdriver (Bit supplied with Product) (if applicable)
•
#2 Phillips Screwdriver or 1/4" Slotted Screwdriver
•
Torque Screwdriver
•
Large screwdriver or other flat tool
•
Hex wrench, 1.5mm (Supplied with Product)
•
Heavy tweezers or needle-nose pliers
Procedure
ATTENTION
You must replace your antenna with the same type, elbow, or straight.
Stainless steel must be replaced with stainless steel, aluminum with
aluminum. Changing to a different antenna type is not permitted by approval
agencies.
CAUTION
Take precautions against electrostatic discharge to prevent damaging the
sensor module.
WARNING
POTENTIAL ELECTROSTATIC CHARGING HAZARD
The integrally mounted antenna shroud is made of Teflon® and has a surface
resistance greater than 1Gohm per square. When the WCX Valve Position
Sensor is installed in potentially hazardous locations care should be taken not
to electrostatically charge the surface of the antenna shroud by rubbing the
surface with a cloth, or cleaning the surface with a solvent. If electrostatically
charged, discharge of the antenna shroud to a person or a tool could possibly
ignite a surrounding hazardous atmosphere.
Revision 1
OneWireless XYR 6000 Wireless Valve Position Sensor User's Manual
1/15/09
6. 5BMaintenance/Repair
6.2. Replacing Antenna
41