Figure - Honeywell KTR 2280A Installation Manual

SYSTEM INSTALLATION MANUAL
(9) Carefully break the shield loose. Strip off the insulation from the center conductor as
shown in Figure 2-9.
Figure 2-9 (Sheet 1 of 1) Quadraxial Cable Preparation
(10) Install 0.25 inch (6.35 mm) length of shrink tubing over the middle shield stub to prevent
possible shorts to the outer shield as shown in Figure 10.
Figure 2-10 (Sheet 1 of 1) Quadraxial Cable Preparation
(11) Connector Assembly
• Install the ferrule over the center shield and solder.
• Slip the cable into the connector housing as shown in Figure 2-11.
• Solder the center conductor to the center terminal.
• Pull up the outer shield and solder to the bottom stem.
• Install shrink tubing over the entire assembly to the bottom of the connector
housing as shown in Figure 2-11.
• Install the horse shoe shaped insert for a 50 ohm impedance match.
© Honeywell International Inc. Do not copy without express permission of Honeywell.
KTR 2280A
Page 2-9
15 May 2017