Joerns Healthcare Hoyer HPL700 User Instruction Manual page 8

Hoyer
®
HPL700
Step 7
7. Attach the front and rear covers (Figures 4 and 5), using the screws provided.
8. Remove the key ring fastener from the boom actuator mounting bracket. Remove the pin
(Figure 5).
9. Carefully remove the orange tie from the lifter actuator that is attached to the mast (Figure 5).
10. Align the upper end of the lifter actuator and boom actuator mounting bracket (Figure 6).
Insert the pin. Install the key ring fastener.
11. To connect the spreader bar to the boom, see instructions on page 16.
12. Plug the hand control and actuator cables into the bottom of the controller. Refer to the figures
on page 10 or 11 for correct positions.
8
Figure 4
Boom
Control
Leg Control
Figure 6
Steps 8, 9
Step 10
English
Step 7
Figure 5