Step - Joerns Healthcare Hoyer HPL700 User Instruction Manual

English

Step 5

3. Lift the mast assembly from the base. The assembly needs to be rotated and positioned close
to vertical so the handle is to the rear of the lift (Figure 3).
Do not damage the cord that runs from the mast to the base. This can lead to the leg
spreader actuator not functioning.
4. Position the mast assembly into the base socket. Full engagement of the mast is indicated by
alignment of the 5/8" bolt hole between the mast and the base (Figure 3).
Avoid trapping fingers. Keep fingers away from the end of the mast when inserting into the
base socket.
5. Insert 5/8" bolt and nut removed in Step 2, and tighten until snug.
6. Insert the 3/8" carriage bolt and nut removed in Step 2, and tighten until snug.
Step 6
WARNING
WARNING
Step 4
Hoyer
HPL700
Figure 3
®
7