Input Source Composition - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

Input source composition

You can use the video system's API to combine up to four input
sources in a single main video stream.
The maxmium number of different input sources depends on the
video system:
Video system different input sources
Room Kit, SX20
Codec Plus, Room 55, Room 70,
MX200 G2, MX300 G2
SX80, MX700, MX800
SX10, DX70, DX80
D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration
(page 1 of 2)
Source composition
Composition layout
You can choose between two layouts:
Maximum number of
• Equal
• PIP (only available when composing two input sources)
2
The layouts are fixed, so you cannot modify the image sizes, or
3
move the PIP.
The composition and layout can be modified at any time, both in
4
call and outside of call.
Not applicable
Selfview
Selfview shows the same composed image that is being sent to
the far end.
Individual camera control
You can control individual cameras using API commands
(
xCommand Camera *
user interface.
When you select a camera in the user interface, the main video
stream will automatically switch from the composed video stream
to the single stream from the chosen camera.
Change compositions and layouts on demand
Input source composition is only available using API commands;
we don't provide a dedicated user interface for it.
To be able to easily change compositions and layouts on demand,
we recommend that you use macros and create a custom user
interface panel (in-room control panel) for it.
Peripherals Maintenance
), but you cannot use the controls on the
162
Administrator Guide
System settings
Layouts
Equal
Number of sources: 2
Number of sources: 3
Number of sources: 4
Picture-in-Picture (PIP)
Number of sources: 2
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Appendices Appendices