Cisco TelePresence SX20 Quick Set Administrator's Manual page 48

Cisco TelePresence SX20 Quick Set

Introduction
Connect monitor
(page 2 of 2)
Manual setup
The automatic setup works well for common single monitor, and
dual monitors scenarios. For more complex scenarios, you may
need manual configuration.
Sign in to the web interface and navigate to
to find the settings referred below.
Set a role for each Set the number of
monitor monitors
Define a role for each monitor Set the number of monitors
with the Video > Output > with different layouts in
Connector n > MonitorRole your setup with the
setting. Monitors
Choose monitor roles that When set to Auto, the video
match your monitor setup. system automatically detects
if a monitor is connected to a
Only one monitor can have
connector, and thereby also
monitor role First.
determines the number of
monitors in the setup.
The other options allow you
to fix a single, or dual monitor
setup; and to dedicate one
monitor for presentations.
Example:
Two monitors in total, and the second monitor is dedicated to only
show presentations:
• Video > Monitors: DualPresentationOnly
• Video > Output > Connector 1 > MonitorRole: Auto
• Video > Output > Connector 2 > MonitorRole: Auto
• UserInterface > OSD > Output: Auto
D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration Peripherals Peripherals
Setup > Configuration,
Choose on which
monitor to display
messages and indicators
Define on which monitor to
Video >
display the messages and
setting.
indicators on-screen with the
UserInterface > OSD > Output
setting.
When set to Auto, the video
system determines which
monitor to use based on the
number of the connector.
Maintenance
Set the monitor
resolution and refresh
rate
The video system reads the
native resolution of a monitor
and outputs this if possible.
Typically, this gives the best
possible picture for the
monitor.
If auto-detection of resolution
and refresh rate fails, you must
set the resolution manually
with the Video > Output >
Connector n > Resolution
setting.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
48
Administrator Guide
System settings Appendices
About the number of
monitors and the role of
each monitor
The Video > Output > Connector n >
MonitorRole setting assigns a role to the
monitor that is connected to the output.
The monitor role decide which layout (call
participants and presentation) will appear
on the monitor.
Monitors with different monitor roles get
different layouts.
The Video > Monitors setting must reflect
the number of different layouts in your
room setup.
Note that a monitor can be reserved for
presentations.