Battery Information - Honeywell CV31A User Manual

CV31 Compliance Insert
Model CV31A
For Users in English-Speaking Regions (en)
Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for
future reference.
Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of
accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation,
may void the compliance of this product and may result in the loss of the user's authority to operate the equipment.
Caution: For vehicle installations observe all warnings and cautions contained in the installation instructions. CV31A
installations that use a DC/DC converter should only be performed by qualified Intermec-trained Service Technicians.
Caution: For use with Intermec battery pack Model 1021AB01 only. See battery instructions. For power supply, use Intermec
Models 9006AE01, 9004AE03, or 9007AX01. No user-serviceable parts.
Caution: For continued protection against risk of fire, replace only with same type and rating of fuse.

Battery Information

Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic
materials if mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns.
Keep away from children. Promptly dispose of used battery pack according to the instructions.
Battery Recycling Information
This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with
the solid waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
Li-ion Li-ion
802.11 Radio Precaution Statement
Caution: Users are responsible for configuring the channels of operation that comply with their country regulatory standards.
A Wireless Network Administrator should review the operating restrictions detailed within the Access Point installation
manual.
Radiation Exposure Statement
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE
C95.1, Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102,
and European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF)
radiation.
Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the
limits established for this equipment.
When installing and using this product, a 20 cm (7.87 in) passing distance must be maintained from the body or head of the user or
nearby persons and the antenna. The antenna must not be touched during transmitter operation.
For Users in the U.S.A. and Canada
U.S.A. Digital Emissions Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to casue harful interference in which case the user wil be required to the correct the interference at their own
expense.
Complies with
IDA Standards
DA 102905
1