Honeywell CV31A User Manual page 34

Canadian Digital Apparatus Compliance
This device complies with Industry Canada license-exempt RSS standards. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that
can cause undesired operation.
CAN ICES-3 (A)/NMB-3 (A)
802.11a Radio Precaution Statement
802.11a wireless LAN 5150 to 5250 MHz (5.15 to 5.25 GHz) (5 GHZ radio channels 34 - 48) is restricted to indoor operations to
•
reduce harmful interference to co-channel Mobile Satellite System (MSS) operations.
The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p.
•
limit.
The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specified for point-
•
to-point and non point-to-point operation as appropriate.
Be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and
•
5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This radio transmitter IC: 1693B-CV31A1 has been approved by Industry Canada to operate with the antenna types listed below with
the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Description
Dual-Band Omnidirectional
Patch
For Users in Europe
EN 55022/CISPR 22 Compliance
Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
Caution: 802.11a wireless LAN 5150 to 5350 MHz (5.15 to 5.35 GHz) is limited to indoor use only.
Note: Dynamic Frequency Selection and Transmit Power Control are required in the 5250 to 5350 MHz and 5470 to 5725 MHz
frequency range.
EU - R&TTE Declaration
Intermec Technologies Corporation declares that this device is in compliance with the essential requirements and other relevant
provisions of R&TTE Directive (1999/5/EC). To find the EU Declaration of Conformity, go to www.intermec.com > Products >
Computers > Fixed Vehicle Computers > CV31 > Manuals tab and then scroll down to Regulatory Information.
This product is marked with this logo and uses radio frequency bands that are harmonized throughout the
European Community.
This equipment may be operated in the following countries without restriction:
AT BE BG CH
IS IT LI LT
Restrictions (Revision ERC/REC 70-03 E 2012-07, Annex 3 Band A)
NO This subsection does not apply for the geographical area within a radius of 20 km from the center of Ny-Ålesund.
Für Anwender in Deutschland (de)
Vorsicht: Diese Kennzeichnung weist darauf hin, dass der Benutzer vor dem Gebrauch alle mitgelieferten Unterlagen lesen
soll. Diese Ergänzung muss zur zukünftigen Bezugnahme aufgehoben werden.
Die Benutzer dieses Produkts werden darauf hingewiesen, nur Zubehörteile und Peripheriegeräte zu verwenden, die von Intermec
Technologies Corporation genehmigt sind. Falls nicht empfohlene Zubehörteile verwendet oder an diesem Produkt Änderungen
vorgenommen werden, die nicht von Intermec Technologies Corporation genehmigt sind, kann dadurch die behördliche Konformität
des Produkts verletzt werden und der Benutzer die Berechtigung zur Verwendung des Geräts verlieren.
Vorsicht: Bei Fahrzeuganwendungen sind sämtliche Warnungen und Vorsichtshinweise der Installationsanleitung zu
beachten. CV31A installations that use a DC/DC converter should only be performed by qualified Intermec-trained Service
Technicians.
2
2.4 GHz Gain (dBi)
3.0
3.0
CY CZ DE DK
LU LV MK MT
5.0 GHz Gain (dBi)
5.0
EE ES FI FR
NL PL PT RO
Impedance (Ohms)
50
50
GB GR HR HU
SE SI SK TR
IE