Makita HW1300 Instruction Manual page 9

1
2
► 1 . Pressure-resistant water hose 2. Nut of the cou-
pling sleeve 3. Coupling sleeve
NOTE: If you connect the pressure-resistant water
hose to the faucet using a coupling sleeve, attach it to
the both ends of the hose.
2. Connect the pressure-resistant water hose to the
faucet. Apply a suitable itting such as hose band or
water tap joint to secure the hose end with the faucet.
1
► 1 . Hose band 2. Water tap joint 3. Pressure-
resistant water hose
NOTE: The itting depends on the shape of the faucet
to which you connect. Prepare a suitable commercial-
ly-bought itting.
3. Attach the water hose connector to the inlet (with
the faucet marking) and then insert the coupling sleeve.
1
► 1 . Coupling sleeve 2. Water hose connector 3. Inlet
3
2
3
3
2
Connecting/disconnecting the
nozzle
CAUTION:
Always lock the trigger when con-
necting/disconnecting the nozzle.
Insert the end of the nozzle into the slot on the trigger
gun and turn it in the direction of the arrow as shown in
the igure. To disconnect, turn the nozzle in the reverse
direction while pressing it toward the trigger gun.
1
► 1 . Trigger gun 2. Slot 3. End of the nozzle
Some optional nozzles require the connecting joint
(optional accessory) to attach to the trigger gun. Attach
the connecting joint to the trigger gun in the same way
as the nozzle.
1
► 1 . Nozzle 2. Connecting joint 3. Trigger gun
NOTE: The connecting joint is needed when using
the nozzles included with another model, HW112 or
HW121.
Connecting the foam nozzle
CAUTION:
Always lock the trigger when con-
necting/disconnecting the nozzle.
Prepare a detergent before using the foam nozzle.
1. Remove the nozzle from the tank by rotating the
nozzle counterclockwise. Attach the nozzle to the trig-
ger gun.
9 ENGLISH
3
2
2 3