Makita HW1300 Instruction Manual page 7

1
► 1 . Catch 2. Handle
Supplying water from a tank/
reservoir
Optional accessory
You can supply water from a tank or reservoir instead
of a faucet.
Replace the water hose connector with the suction hose
set (optional accessory). When connecting the suction
hose set, disconnect the ilter case from the hose and
attach it to the inlet on the high pressure washer. Then,
connect the hose to the ilter case.
1 2
4 5
► 1 . Tank/reservoir 2. Suction hose set 3. Water hose
connector 4. Hose 5. Filter case 6. Inlet on the high
pressure washer
NOTICE:
Always use Makita's suction hose set.
NOTICE:
Always keep 1.0 m (3.28 ft) or less in
height between the inlet on the high pressure
washer and the water surface. Otherwise, the high
pressure washer will be unable to take the water up
into the pump.
2
3
6
7 ENGLISH
To introduce water into the hose, remove the nozzle
from the trigger gun and switch on the high pressure
washer while the trigger is squeezed. Once water is
ejected stably from the trigger gun, release the trigger
and attach the nozzle for your purpose.
1
► 1 . Trigger gun
NOTE: When water is not ejected, detach the suction
hose set and soak it in water. Then reconnect it to the
high-pressure washer.
► 1 . Suction hose set
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Assembling the carrying handle
For the HW1200 only
1. Join the front and rear halves of the handle by
aligning the screw holes on the high pressure washer
body.
1