Connecting The High-Pressure Hose - Makita HW1300 Instruction Manual

3
► 1 . Front half of the handle 2. Rear half of the handle
3. High pressure washer body
2. Secure the carrying handle with screws(7 pcs).

Connecting the high-pressure hose

For the HW1200 only
Connect the high-pressure hose to the outlet (with the
gun marking). Turn the nut on the high-pressure hose
clockwise while screwing it onto the screw thread of the
outlet.
1
► 1 . Outlet 2. Nut
1
2
2
CAUTION:
Make sure that the high-pressure
hose is securely connected. A loose connection
may blow the high-pressure hose off, resulting in a
personal injury.
Attaching the trigger gun
Connect the high-pressure hose to the inlet on the
trigger gun. Turn the nut on the high-pressure hose
clockwise while screwing it onto the screw thread on
the inlet.
1
► 1 . Inlet 2. Nut
CAUTION:
Make sure that the high-pressure
hose is securely connected. A loose connection
may blow the high-pressure hose off, resulting in a
personal injury.
Connecting to a faucet
CAUTION:
Always use a pressure-resistant
water hose with ø13 mm or larger diameter and
connect to the faucet using a proper ittings.
Otherwise, the water hose and/or the itting may
break and cause personal injury.
NOTICE:
Use a pressure-resistant water hose
as short as possible. The amount of intake water
should be higher than the max feed volume of the
pump.
NOTICE:
If you connect to the mains for drink-
ing water, use a backlow preventer valve which
meets the regulations in your region.
Prepare a pressure-resistant water hose. Attach the
coupling sleeve to one end and connect the other end
to the faucet as follows.
1. Remove the nut on the coupling sleeve and pass
the pressure-resistant water hose through the nut.
Insert the end of the hose into the coupling sleeve and
then tighten the nut.
8 ENGLISH
2