Makita HW1300 Instruction Manual
Hide thumbs Also See for HW1300:

Advertisement

INSTRUCTION MANUAL
High Pressure Washer
HW1200
HW1300
DOUBLE INSULATION
Read before use.

Advertisement

Table of Contents
loading

Summary of Contents for Makita HW1300

  • Page 1 INSTRUCTION MANUAL High Pressure Washer HW1200 HW1300 DOUBLE INSULATION Read before use.
  • Page 2 WARNING Machines shall not be used by children. Children should be • supervised to ensure that they do not play with the machine. This machine is not intended for use by persons (including chil- • dren) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge.
  • Page 3: Specifications

    Model HW1200 Sound pressure level (L ) : 72 dB(A) Uncertainty (K) : 3.8 dB(A) Not suitable for connection to the potable Model HW1300 water mains. Sound pressure level (L ) : 76 dB(A) Uncertainty (K) : 2.4 dB(A) Intended use The noise level under working may exceed 80 dB (A).
  • Page 4: Ec Declaration Of Conformity

    ) : 4.11 m/s of persons unless they wear protective clothing. Uncertainty (K) : 1.5 m/s To reduce the risk of injury, close supervision is Model HW1300 necessary when the product is used near children. Vibration emission (a ) : 4.86 m/s Water that has lowed through backlow pre- Uncertainty (K) : 1.5 m/s...
  • Page 5: Functional Description

    18. Do not pull the cord and/or hose to move the pressure washer. high pressure washer body. This will damage For the HW1300 the cord, hose, and connecting parts and result in a short circuit or functional defects. Turn the power switch clockwise or counterclockwise 19.
  • Page 6 CAUTION: Do not tamper with or adjust the safety valve setting. Hose reel For the HW1300 only A spiral jet is ejected. Suitable for removing stubborn dirt. To unreel the hose, take the end of the hose out of the catch irst. Unfold the handle and turn it clockwise.
  • Page 7 NOTICE: Always use Makita's suction hose set. NOTICE: Always keep 1.0 m (3.28 ft) or less in height between the inlet on the high pressure washer and the water surface. Otherwise, the high pressure washer will be unable to take the water up into the pump.
  • Page 8: Connecting The High-Pressure Hose

    CAUTION: Make sure that the high-pressure hose is securely connected. A loose connection may blow the high-pressure hose off, resulting in a personal injury. Attaching the trigger gun Connect the high-pressure hose to the inlet on the trigger gun. Turn the nut on the high-pressure hose clockwise while screwing it onto the screw thread on the inlet.
  • Page 9 Connecting/disconnecting the nozzle CAUTION: Always lock the trigger when con- necting/disconnecting the nozzle. Insert the end of the nozzle into the slot on the trigger gun and turn it in the direction of the arrow as shown in the igure. To disconnect, turn the nozzle in the reverse direction while pressing it toward the trigger gun. ► 1 .
  • Page 10: Operation

    Connect the end of the high-pressure hose to the trigger gun. For the HW1200, connect the other end to the high pressure washer. For the HW1300, unreel the hose all the way to the end. Connect the high pressure washer to the faucet and then open the faucet.
  • Page 11: After Operating

    Squeeze the trigger until the remaining water in the high pressure washer is discharged. Do not run the motor for longer than 1 minute. ► 1 . High pressure hose For the HW1300, reel the hose and ix the end of the hose. Switch off the high pressure washer and unplug it from the mains.
  • Page 12: Maintenance And Storage

    Cleaning the ilter Detach the water hose connector and remove dirt and debris from the inside of the ilter. ► 1 . Catch 2. Handle NOTICE: To prevent the high-pressure hose from being damaged, remove the remaining water in the hose before storing. ► 1 . Water hose connector 2. Filter 3. Sealing ring When using the suction hose set (optional accessory), take the ilter out of the ilter case and remove dirt and MAINTENANCE &...
  • Page 13: Troubleshooting

    Makita Authorized or Factory Service Centers, always using Makita replacement parts. TROUBLESHOOTING Before asking for repairs, conduct your own inspection irst. If you ind a problem that is not explained in the manual, do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace- ment parts for repairs. State of abnormality Probable cause (malfunction) Remedy The washer does not start.
  • Page 14: Optional Accessories

    OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool speciied in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
  • Page 15 Under body spray lance Connecting joint An extra long spray lance with angled nozzle. Best for A joint to connect with a nozzle from other model. cleaning hard-to-reach areas such as car under body NOTE: The connecting joint is needed when using and roof gutter.
  • Page 16 Jan-Baptist Vinkstraat 2, M a k i t a E u r o p e N . V . 3070 Kortenberg, Belgium 3-11-8, Sumiyoshi-cho, M a k i t a C o r p o r a t i o n Anjo, Aichi 446-8502 Japan 885542B229 w w w .

This manual is also suitable for:

Hw1200

Table of Contents