After Operating - Makita HW1300 Instruction Manual

Hold the trigger gun irmly. The
CAUTION:
trigger gun recoils when you pull the trigger.
CAUTION:
Always hold the trigger gun by the
grip and barrel when cleaning. While the motor is
running, do not touch any part of the high pres-
sure washer body other than the carrying handle
and power switch.
NOTICE:
Be careful not to pull the trigger gun
forcibly during operation. It may cause the high
pressure washer to fall over.

After operating

CAUTION:
After operating, always perform
the procedure described in this manual. Residual
pressure in the trigger gun or high pressure washer
can cause personal injury or damage to the pump
inside.
1. After operating, leave the power switch on.
2. Close the faucet and disconnect the water hose
from the high pressure washer.
3. Squeeze the trigger until the remaining water in
the high pressure washer is discharged.
Do not run the motor for longer than 1 minute.
4.
Switch off the high pressure washer and unplug it
from the mains.
► 1 . Power switch
5. Disconnect the high-pressure hose from the trig-
ger gun.
1
2
► 1 . Trigger gun 2. High-pressure hose
For the HW1200, also disconnect the high pressure
hose from the high pressure washer.
► 1 . High pressure hose
For the HW1300, reel the hose and ix the end of the
hose.
11 ENGLISH
1
1