Multinode/Wsg Installation; Installation Tasks - Honeywell OW-CDX050 User Manual

Table of Contents

Advertisement

Installation Overview

Multinode/WSG installation

Multinode/WSG installation
Honeywell's multinode/ WSG requires physical mounting and installation on site
following the execution of the preinstallation requirements. The location of all
multinodes should be determined to ensure optimum operation in a wireless network.

Installation tasks

WARNING
Multinodes and wireless system gateways must be professionally installed in
accordance with the requirements specified in the 'OneWireless Multinode
Agency Compliance Professional Installation Guide.' Only the specified
power settings, antenna types and gains and cable lengths (attenuation) as
outlined in the installation guide are valid for multinode installations.
Before the multinode is installed at the site location there are a number tasks which must
be completed to properly set up the unit. Table 4 outlines these tasks to be performed for
each multinode/WSG installation. For example, the site location of the multinode/WSGs
should be identified and prepared before the multinode is installed. Additionally, you
should verify that the multinode contains the latest version firmware and ensure that it is
configured properly for the network in which it is designed to operate. Follow the tasks
listed in Table 4 to complete a multinode installation. The page numbers reference
additional information and details on each task.
Task
Preparing the multinode
installation site(s)
Initial bench configuration of
multinode
(See
Configuration
section for
procedures.)
24
Table 4 Multinode installation tasks
a.
Inspect the multinode
b.
Identify multinode site
c.
Assemble and install mounting
page 27.
d.
Construct conduit and cable runs for multinode
power and Ethernet
e. Bench setup and connection to multinode. See
Initial Configuration
f. Verify firmware version and update if
necessary. See
OneWireless Multinode User's Guide
Action
hardware. See page 26.
locations. See page 26.
hardware. See
See page 27.
on page 35.
Verify firmware version
on page
Done
R110
6/08

Advertisement

Table of Contents
loading

Table of Contents