Installation - Honeywell ADPRO iFT Series Quick Setup Manual

ADPRO
9. Click OK to close the window.
Note
You can check the XO device information by running the following commands when you are
connected to the device with a monitor and keyboard.
ALT + F1
ALT + F7
5.2.3

Installation

Note
Webserver is disabled by default starting with ADPRO XO 4.5. It can only be reenabled by a
technician on a system in which an admin user has enabled the technical grant. To install the client
software using the XO device's web page, the webserver must be enabled by the technician which is
a security risk. You can get the client software from the release DVD or from the support site
(www.xtralissecurity.com).
To install the XO client software via the XO device's web page, proceed as follows:
1. Connect your PC to the XO device's eth0 port with an RJ45 network cross cable or via the network
switch/router on the eth0 port.
2. Open Internet Explorer and enter the XO device's IP address, followed by /setup.php
For example:http://10.0.0.10/setup.php
3. Click setup.exe.
27929_07
To display the IP details
To display the cameras in matrix layout
ADPRO iFT Series Quick Setup Guide
9