Mmrp-Flood-Optimization - Cisco ASR 9000 Series Reference Manual

Provider Backbone Bridge Commands

mmrp-flood-optimization

To enable flood optimization for PBB over VPLS, use the mmrp-flood-optimization command on the core
bridge in the PBB core configuration submode. To disable the flood optimization for PBB over VPLS, use
the no form of this command.
mmrp-flood-optimization
no mmrp-flood-optimization
Syntax Description
This command has no keywords or arguments.
Command Default
Disabled.
Command Modes
PBB core configuration
Command History
Release
Release 5.1.2
Usage Guidelines
Flood optimization is enabled on all the pseudo-wires in the VFI associated with the core bridge domain. This
feature is supported only in the standard full mesh topology of a VPLS network.
Task ID
Task ID
l2vpn
Examples The following example shows how to enable flood optimization for PBB over VPLS:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group pbb
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain pbb-core
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# pbb core
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pbb-core)# mmrp-flood-optimization
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pbb-core)# end
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operation
read, write
mmrp-flood-optimization
6.1.x
417